Check the Available 350-601 Exam Dumps with 455 QA's UPDATED 2023
Download 350-601 Exam Dumps Questions to get 100% Success in Cisco
NEW QUESTION # 10
An engineer configures the properties of a cisco UCS cisco integrated Management controller network adapter for a standalone cisco C-Series server. The Fallback Timeout in the vNIC was set to 600. When the failure occurs. The secondary must be used and then fallback when the primary interface becomes available again. Which action be taken to meet these requirements?
- A. Increase Cos to 6.
- B. Set default VLAN on the adapters.
- C. Enable Uplink failover.
- D. Disable VNTAG mode.
Answer: C
Explanation:
Enable Uplink Failover check box - Check this box if traffic on this vNIC should fail over to the secondary interface if there are communication problems. VNTAG mode is required for this option.
Failback timeout field - After a vNIC has started using its secondary interface, this setting controls how long the primary interface must be available before the system resumes using the primary interface for the vNIC. Enter a number of seconds between 0 and 600. VNTAG mode is required for this option.
https://www.cisco.com/en/US/docs/unified_computing/ucs/c/sw/gui/config/guide/1.5/b_Cisco_UCS_C-series_GUI_Configuration_Guide.151_chapter_01001.html
NEW QUESTION # 11
An engineer is using REST API calls to configure the cisco APIC. Which data structure must be used within a post message to receive a login token?
A)
B)
C)
D)
- A. Option D
- B. Option A
- C. Option B
- D. Option C
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/rest_cfg/2_1_x/ b_Cisco_APIC_REST_API_Configuration_Guide/b_Cisco_APIC_REST_API_Configuration_Guide_chapter_01.html
NEW QUESTION # 12
Refer to the exhibit.
A flapping link issue has been reported on the vPC keepalive link. A packet capture has been activated on the Cisco Nexus switch. What is the destination IP address of the vPC keepalive packets that are sent by the switch?
- A. 192.168.254.1
- B. 192.168.254.2
- C. 192.168.254.4
- D. 239.255.70.83
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus3000/sw/interfaces/92x/b-cisco-nexus-3000-nx-os-interfaces-configuration-guide-92x/b-cisco-nexus-3000-nx-os-interfaces-configuration-guide-92x_chapter_0110.html
NEW QUESTION # 13
Which service profile is affected if the default host firmware policy in Cisco UCS Manager is changed?
- A. any service profile that uses the global-default host firmware policy
- B. any service profile that uses a user-created host firmware policy
- C. any service profile that has no host firmware policy defined
- D. any service profile that is not in the root sub-org
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Firmware- Mgmt/3-1/b_UCSM_GUI_Firmware_Management_Guide_3_1/ b_UCSM_GUI_Firmware_Management_Guide_3_1_chapter_011.html
NEW QUESTION # 14
Refer to the exhibit.
An engineer configures a new application profile using REST API and receives this error message. Which method can be used before the application profile can be configured?
- A. GET to aaaListDomains
- B. POST to aaaLogin
- C. POST to aaaLogout
- D. POST to aaaRefresh
Answer: B
NEW QUESTION # 15
An engineer is implementing security on the Cisco MDS 9000 switch. Drag drop the descriptions from the left onto the correct security features on the right.
Answer:
Explanation:
NEW QUESTION # 16
Which configuration statically assigns VSAN membership to a virtual Fibre Channel interface?
- A. switch<config-vsan-db)# vsan 100 bind interface vfc 31
- B. switch(config-vsan-db)# vsan 100 interface vfc 31
- C. switch(config-vsan-db># vsan 100 fc 3/1
- D. switch(config-vsan-cb># vsan 100 bind interface fc 3/1
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/configuration/guide/cli/ CLIConfigurationGuide/vsan.html
NEW QUESTION # 17
What are two requirements when planning a Cisco HyperFlex All Flash standard cluster installation using three HX240c M5 servers? (Choose Two)
- A. The cluster deployment type must support a mix of HDD and SSD.
- B. If the Jumbo MTU option in the HyperFlex installer is enabled, then jumbo frames must also be enabled on the upstream switches.
- C. The hypervisors must be installed to Cisco FlexFlash SD cards.
- D. The servers must be discovered, unassociated, and connected to each fabric interconnect.
- E. If the Jumbo MTU option in the HyperFlex installer is enabled, then jumbo frames do not have to be enabled on the upstream switches.
Answer: B,D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/hyperconverged_systems/HyperFlex_HX_DataPlatformSoftware/ AdminGuide/3_5/ b_HyperFlexSystems_AdministrationGuide_3_5/b_HyperFlexSystems_AdministrationGuide_3_5_chapter_0111
NEW QUESTION # 18
Refer to the exhibit.
Refer to the exhibit. SVR-A in EPG-A/BD-A fails to reach SVR-B in EPG-B/BD-B. Which two conditions should be verified to analyze the traffic between the two EPGs? (Choose two.)
- A. A contract exists between EPG-A and EPG-B and allows the traffic.
- B. EPG-A and EPG-B are excluded from the preferred group.
- C. The bridge domain for EPG-B floods ARP packets.
- D. SVR-B is learned as an endpoint in EPG-B from Node-112.
- E. Limit Endpoint Learning is disabled on the bridge domain for EPG-
Answer: A,D
NEW QUESTION # 19 
Refer to the exhibit. An engineer is troubleshooting intermittent connectivity issues between the client PC and the DHCP server. What does the last package captured from the Cisco Nexus 2000 Series Switch indicate?
- A. The client sends a unicast message to receive an IP address from the DCHP server.
- B. The DHCP server sends an IP address via a broadcast message.
- C. The DCHP server releases the IP address from the client.
- D. The client receives an IP address from the DHCP server.
Answer: C
NEW QUESTION # 20
A host in EPG Client wants to talk to a webserver in EPG Web. A contract with default settings is defined between EPG Client and EPG Web, which allows TCP communication initiated by the client toward the webserver with TCP destination port 80.
Which statement is true?
- A. The host in EPG Client can connect to TCP destination port 80 on the webserver in EPG Web. The webserver will not be able to initiate a separate TCP connection to a host port with TCP source port 80.
- B. If EPG Web is made a preferred group member, a contract between EPG Client and EPG Web is no longer required for the host in EPG Client to reach the webserver in EPG Web.
- C. If vzAny is configured to consume and provide a "deny all" contract, traffic between EPG Client and EPG Web is no longer allowed.
- D. The host in EPG Client can connect to TCP destination port 80 on the webserver in EPG Web. The webserver can initiate a separate TCP connection to a host port with TCP source port 80.
Answer: D
NEW QUESTION # 21
Drag and drop the fields for configuring a full state backup file of the Cisco UCS Manager from the left onto the descriptions on the right.
Answer:
Explanation:
Explanation
Diagram Description automatically generated
NEW QUESTION # 22
In an FCoE environment, for which two sets of data must an interface that implements the PAUSE mechanism always provision sufficient ingress buffer? (Choose two.)
- A. frames that were processed and transmitted by the transmitter after the PAUSE frame left the sender
- B. frames that were sent on the link but not yet received
- C. frames that were processed and transmitted by the transmitter before the PAUSE frame left the sender
- D. frames that were sent on the link and received
- E. frames that were sent with high credit
Answer: B,C
Explanation:
Section: Storage Network
NEW QUESTION # 23
What happens to the default host firmware policy after a Cisco UCS Manager upgrade?
- A. It is set to match the host firmware policy.
- B. It is assigned to all the service profiles that include a host firmware policy.
- C. It is replaced by a new default policy without any firmware entries.
- D. It is updated to contain the firmware entries of all the components
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Firmware-Mgmt/3-1/b_UCSM_GUI_Firmware_Management_Guide_3_1/b_UCSM_GUI_Firmware_Management_Guide_3_1_chapter_0111.html
NEW QUESTION # 24
An engineer is configuring a vHBA template in UCS Manager. The engineer needs to specify the logical addresses used by the vHBA and the path through which the SAN traffic flows. Which two resources must be specified in the vHBA template? (Choose two.)
- A. VLAN ID
- B. MAC addresses
- C. WWPNPool
- D. WWNN
- E. Fabric ID
Answer: C,E
Explanation:
Explanation
https://www.cisco.com/c/en/us/products/collateral/servers-unified-computing/ucs-manager/whitepaper_c11-6973
NEW QUESTION # 25
A network architect must design an automation solution to initially support networking and also support the server infrastructure in the future. To keep configuration consistency, the network team requires a solution that enforces the desired state of the network and reverts any manual configuration. Which solution meets these goals?
- A. NX-API
- B. Puppet
- C. Ansible
- D. Terraform
Answer: B
NEW QUESTION # 26
Refer to the exhibit.
What must be connected to clear the HA NOT READY status?
- A. management ports
- B. network uplinks
- C. Layer 1-Layer 2 ports
- D. server chassis
Answer: D
NEW QUESTION # 27
A network engineer must SPAN only the ingress traffic of a Cisco MDS 9000 series switch from interface fc
1/23 to interface fc 1/24. Which two configuration must be applied to complete this task? (Choose two)
- A. Option D
- B. Option B
- C. Option A
- D. Option C
Answer: C,D
NEW QUESTION # 28
Refer to the exhibit.
What must be connected to clear the HA NOT READY status?
- A. management ports
- B. network uplinks
- C. Layer 1-Layer 2 ports
- D. server chassis
Answer: D
Explanation:
Section: Network
NEW QUESTION # 29
An engineer changed a configuration and must perform a rollback. Which statement applies to a Cisco Nexus 5600 Series switch?
- A. A system checkpoint is generated automatically when the running configuration is saved to NVRAM.
- B. A user who is assigned to the network-operator user role can perform a rollback.
- C. The configuration rollback functionality is disabled when FCoE is enabled.
- D. Errors are skipped when an atomic rollback type is triggered.
Answer: C
Explanation:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/system_management/503_n1_1/ cisco_n5k_system_mgmt_cg_rel_503_n1_1_chapter11.pdf
https://www.google.com/url?sa=t&source=web&rct=j&url=https://www.cisco.com/c/en/us/td/docs/switches/ datacenter/nexus5000/sw/system_management/503_n1_1/ cisco_n5k_system_mgmt_cg_rel_503_n1_1_chapter11.pdf&ved=2ahUKEwjQ8ubTuK3xAhWm3jgGHZ9gB
0oQFjAAegQIBRAC&usg=AOvVaw2j0nnvXiChAoVooxX2Qx0g
NEW QUESTION # 30
An engineer is using REST API calls to configure the cisco APIC. Which data structure must be used within a post message to receive a login token?
A)
B)
C)
D)
- A. Option C
- B. Option B
- C. Option D
- D. Option A
Answer: B
NEW QUESTION # 31
An engineer deploys a custom Guest Shell rootfs on a Nexus 9000 Series Switch. Drag and drop the steps from the left into the order required to deploy the solution on the right. Not all options are used.
Answer:
Explanation:
Explanation
A picture containing text Description automatically generated
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/93x/progammability/guide/b-cisco-nex
NEW QUESTION # 32
An engineer created a service profile in Cisco UCS Manager and associated it to a server. The engineer must create a policy if there is a disruptive change applied to the service profile Which policy type must be used to accomplish this goal?
- A. administration
- B. BIOS
- C. reboot
- D. maintenance
Answer: D
NEW QUESTION # 33
......
Best Value Available! 2023 Realistic Verified Free 350-601 Exam Questions: https://dumpstorrent.actualpdf.com/350-601-real-questions.html
