Unique Top-selling HPE6-A45 Exams - New 2022 HP Pratice Exam
Aruba Certified Switching Professional (ACSP) V1 Dumps HPE6-A45 Exam for Full Questions - Exam Study Guide
NEW QUESTION 102
Network administrators need to configure a BGP neighbor on an AOS-Switch. What defines the neighbor as an iBGP neighbor?
- A. Its remote-AS is the same as the QOS-Switch BGP AS
- B. It has BGP synchronization enabled
- C. It has an AS number in the range of 64512 to 645535.
- D. Its update source it set to a private company IP address
Answer: D
NEW QUESTION 103
Refer to the exhibit.
A network administrator wants to add the protections of root guard to the network. Based on the spanning tree topology, on which ports should the network administrator implement root guard?
- A. 1 and 2
- B. 3-24
- C. A1 and A2
- D. 2 and A3
Answer: C
NEW QUESTION 104
Refer to the exhibits.
Exhibit 1
Exhibit 2
Switch-1 has a power issue that causes it to fail. When Switch-1 comes back up, endpoints lose connectivity for a few minutes. The network administrator decides to enter this command on Switch-1:
Switch-1 (config)# vlan 10 vrrp vrid 10 preempt-delay-time 120
Exhibit 2 shows the VRRP configuration just after the change. What is the effect of this change?
- A. Switch-1 and Switch-2 both become Master in their own VRRP virtual router due to the delay timer mismatch. The mismatch must be fixed.
- B. Switch-1 continues to act as it did before the preempt delay time was set. Administrators must plan additional changes to fix the issue.
- C. Switch-1 now waits to take over as Master if it fails and recovers. This should prevent the connectivity issue from occurring again.
- D. Switch-1 experiences an internal error in the VRRP process. This error causes Switch-2 to take over as Master for VLAN 2.
Answer: D
NEW QUESTION 105
An AOS-Switch runs IGMP on A VLAN.
What is a requirement for the switch to be a potential IGMP querier on that VLAN?
- A. The switch must run PIM-SM or PIM-DM on that VLAN.
- B. The switch must have an IP address on that VLAN.
- C. The switch must have IGMP fast leave disabled globally.
- D. The switch must have at least one IGMP group configured on it manually.
Answer: B
Explanation:
Reference: https://support.hpe.com/hpsc/doc/public/display?docId=c05207062
NEW QUESTION 106
A company has AOS-Switches deployed at sites with inexperienced IT staff. The main office network administrators want to track if configurations change on branch switches.
What should be set up for this purpose?
- A. an SNMP trap
- B. an auto-config server
- C. an RMON alarm
- D. an IP SLA profile
Answer: A
NEW QUESTION 107
Refer to the exhibits:
Exhibit 1
Exhibit 2
A network administrator at a university notices high utilization on links between the access layer and core. The output shown in the exhibit is characteristic of samples taken several times an hour during congestion. The administrator suspects file sharing and other unauthorized traffic, and decides to use an ACL to permit only HTTP, HTTPS, and a few other authorized types of traffic.
How can the administrator apply the ACL to address both the security and the congestion problem?
- A. as an inbound VACL on the student VLAN on the access switches
- B. as an inbound VACL on the student VLAN on Switch-1
- C. as an inbound PACL on the link aggregations on Switch-1
- D. as an inbound PACL on the link aggregations on the access switches
Answer: A
NEW QUESTION 108
Refer to the exhibit.
Switch-1 is an AOS-switch that is operating at factory default settings for QoS and has type of service disabled. It receives a frame with 802.1p value 5 on trk1, on VLAN 2. How does the switch treat the frame when it forwards it on TRK2?
- A. It forwards it with normal priority and 802.1p 5
- B. It forwards it with normal priority and 802.1p 0.
- C. It forwards it with higher than normal priority and 802.1p 0.
- D. It forwards it with higher than normal priority and 802.1p 5.
Answer: B
NEW QUESTION 109
Refer to the exhibits.
The network administrator enters the commands shown in Exhibit 2, and Switch-1 and Switch-2 exchange keepalive messages. What is the expected behavior if Switch-1 later fails to receive keepalive messages from Switch-2?
- A. Switch-1 disables interface 1 for 10 seconds, and then re-enables it. The same process repeats twice. If the issue persists, the switch disables the interface permanently.
- B. After two consecutive missed keep-alive packets, Switch-1 sends SNMP traps, and Link 1 stays up until the issue is fixed.
- C. After two consecutive missed keep-alive packets, Switch-1 disables interface 1, and the interface stays disabled until the issue is fixed.
- D. Switch-1 disables interface 1 for 10 seconds and then re-enables it. The interface continues to be re-enabled and disabled every 10 seconds until the issue is fixed.
Answer: C
NEW QUESTION 110
Refer to the exhibit.
Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.
What is a typical issue that could cause this output?
- A. mismatched subnet mask on the VLAN for the link
- B. an issue with VLAN mismatch
- C. a jumbo frame mismatch
- D. asymmetric routing introduced by a routing protocol
Answer: D
NEW QUESTION 111
Refer to the exhibits.
Exhibit 1
Exhibit 2
Exhibit 1 shows a portion of the BGP routing table when the BGP solution was first deployed. Exhibit 2 shows the same portion at the current time. What can explain the current state?
- A. Due to changes in the private network, Switch-1 can no longer reach 192.168.2.1.
- B. Due to changes at ISP 1, Switch-1 now selects a different best route.
- C. Switch-1 can no longer reach ISP 1 at 192.168.1.1.
- D. An administrator has applied a route map on Switch-1 that filters advertised routes.
Answer: B
NEW QUESTION 112
Refer to the exhibits.
Exhibit 1
Exhibit 2
A network administrator sets up PIM-DM to route traffic from the multicast source to clients in VLAN 24.
The server begins to forward multicasts, and the clients are set up to receive them. However, the multicasts do not reach the clients.
Based on the output, what should the administrator verify?
- A. that Switch-1 has selected Switch-2 as its RP for 239.1.1.1
- B. that Switch-2 has PIM-DM enabled on VLAN 10
- C. that state refreshes are enabled on Switch-2
- D. that VLAN 24 on Switch-1 runs both IGMP and PIM-DM
Answer: B
NEW QUESTION 113
AOS-Switches authenticate guests to ClearPass with captive portal. An administrator notices that some guests are unable to reach the captive portal page. What will resolve this issue?
- A. Permit DHCP on the ClearPass Portal.
- B. Permit Allow All MAC-Auth on the CleatPass Portal.
- C. Permit HTTP or HTTPS on the ClearPass Portal.
- D. Permit DNS on the ClearPass Portal
Answer: D
NEW QUESTION 114
Which situation requires an AOS-Switch interface to support MAC-based VLANs?
- A. The interface has an extended MAC ACL applied to it in the inbound direction, and it has multiple tagged VLAN assignments.
- B. The interface is configured to support Local MAC Authentication (LMA), authenticates endpoints against a non-default MAC group, and limits the address count to 1.
- C. The interface is configured to support 802.1X in user-based mode, connects to more than one endpoint at a time, and users are assigned to different dynamic VLANs.
- D. The interface has an extended MAC ACL applied to it in the outbound direction, and it uses VLAN ID as one of the criteria for rules.
Answer: A
NEW QUESTION 115
Exhibit
Switch-1 and Switch-2 connect on interface A23. The Switches experience a connectivity issue. The network administrator sees that both Switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.
What is a typical issue that could cause this output?
- A. An issue with VLAN ID mismatch
- B. Mismatched subnet mask on the VLAN for the link
- C. Asymmetric routing introduced by a routing protocol
- D. A jumbo frame mismatch
Answer: C
NEW QUESTION 116
An AOS-Switch is configured to use captive portal and RADIUS to integrate with an Aruba ClearPass solution. What should the administrator do to enabled the switch to accept change of authorization (CoA) messages from ClearPass?
- A. Enable login privilege globally on the switch
- B. Enable user-role authorization globally on the switch.
- C. Enable dynamic authorization in RADUS server settings.
- D. Enable tunneled node in role-based mode.
Answer: A
NEW QUESTION 117
Exhibit
The exhibits show the current operational state for routes on Switch-3. The company wants Switch-3 to prefer the link to Switch-1 over the link to Switch-2 for all intra-area, inter-area, and external traffic. What can the network administrator do to achieve this goal?
- A. Set the OSPF cost on VLAN 108 higher than 1 on Switch-2 and Switch-3.
- B. Set the OSPF administrative distance on Switch-2 higher than 110.
- C. Set the OSPF area type to normal on all of the switches in Area 1.
- D. Set the cost in the OSPF Area 1 stub command higher than 1 on Switch-2.
Answer: D
NEW QUESTION 118
......
Best way to practice test for HP HPE6-A45: https://dumpstorrent.actualpdf.com/HPE6-A45-real-questions.html
